STP waterproofing
STP waterproofing by Gayatri Tredar
ShaliKote® T-10 / ShaliKote® T-10A is water based bituminous emulsion with finely divided bitumen dispersed in water and is ready for application on wet surfaces.
ShaliKote® T-10 / ShaliKote® T-10A is recommended for waterproofing of leaky walls / surfaces or places where heating of bitumen is not desirable or prohibited.
Our STP Waterproofing:
•Wire brush and clean the surface thoroughly to remove all dirt and loose particles.
• Dilute ShaliKote® T-10 from its pasty consistency to light consistency by adding water in the ratio of 1:1. Apply this diluted material on the roof surface as primer. No dilution should be
done in case of ShaliKote® T-10A.
• When the primed surface is dry and has turned black from its original brown colour, apply ShaliKote® T-10 and allow the emulsion to break. It will turn black from its original brownish
colour.
• When the emulsion has set in, spread coarse sand or crushed stone chips over the surface.
Health & Safety
• Avoid contact with skin / eyes and avoid swallowing.
• Ensure adequate ventilation and avoid inhalation of vapour.
• Wear suitable protective clothing, gloves and eye protection.
• In case of skin contact, rinse with plenty of clean water, then cleanse with soap and water.Do not use solvent to clean the contacted area.
• In case of eye contact, wash with plenty of clean water and seek medical advice.
• If swallowed, seek medical attention immediately. Do not induce vomiting.
Packaging
Available in 20 kg and 200 kg drum.
Storage
Keep in cool and dry place, in air tight container, under shed, away from heat.
Shelf Life
12 months in original unopened sealed conditions.